MPC MyCar Remote Start Instructions

There are two ways to install your MyCar remote starter, which depends whether your EVO module has the H2 option enabled.
On December 1st 2016, we started shipping EVO modules with Option H2 enabled. If you purchased your EVO after that date, you might not need to do any flash updating to the module.

To determine if your module already has H2 enabled, you'll need the service number from the module. The service number can be found just above the bar code on the EVO label like below:

---

Go to www.ifar.ca and type the service number into the search box on the top right corncer of the screen. The service number begins with 001A06.

---

Press "enter" and you will see a display that shows the current status of your EVO module - the firmware that is loaded, and which features/options have been enabled.

---

Scroll down to the section titled "Supported RF Kits". If option H2 is shown as "on" your EVO module is ready for MyCar. Use this link to get your install instructions. If H2 is off, you will need the Flash Link Updater to turn it on. Click here for install instructions.